It prevented my ally radiator eating out for over 10years and that was half the thickness (0.5mm) of a homemade tank (1.0mm)Īnd having actually measured the flow, you dont need 50 psi to get the required 0.9 to 1.4 litres per minute(Weldcraft data) ,unless you require the flow with you standing on the hose or you are filling 30m vertical run of hose. Some Automotive antifreeze for ally radiators works fine. You put in a additive to stop it happening. How long does it take an Ally radiators to eat out on cars? or in a house. I have also replaced their leads for them when they burn out as well.There is a lot of dubious information in the above quoted Yes, people have made their own coolers from submersible pumps and the like. You need about 40-50 psi to get the correct flow through the tig head. The aluminum will also corrode and get sucked in an can plug the head. Submersible pumps will not cut it in the long run and aluminum tanks will eventually eat out. It is on the return side of the torch so there is no real pressure. If it is the radiator you may be able to solder it up or possibly even epoxy. I have worked on quite a few and they are good units.
0 kommentar(er)
